WISMEC Riccardo Reuleaux RX GEN3 Manuel D'utilisation page 14

english
(2) Always remember to change the operational mode to suit the coil material of your atomizer
head to ensure that the temperature control works accurately.
(3) The TC mode only supports a maximum resistance of 1.5 ohms. The device switches au-
tomatically to the VW mode when the resistance is higher than 1.5 ohm. When a Kanthal
coil is applied in the TC mode, the device will also automatically switch to VW mode after
working for 2 seconds.
Switch between current, number of puffs and vaping time: Press the power button 3
times to enter the setup menu. Now press the left regulatory button until the personal vaping
amperes), the total number of puffs and the vaping time. Finally press the power button once
Logo mode: The device is equipped with a logo mode.
While the device is turned on, simultaneously press the power button and the right regulatory
button to enter the logo mode. Use the regulatory buttons to choose between logo "On" and
You can either download our logo or make your own logos which you can import through our
software. The logo must be monochrome, in .bmp format and have a size of 64 x 48 pixels.
- 26 -
Preheat function: While the device is turned on, simultaneously press the power button and
the right regulatory button to enter the setup menu. Now press the right regulatory button to
enter the preheat settings. Use the power button to switch between the preheat power and
the preheat duration. Now use the the regulatory buttons to adjust the preheat wattage or
duration (or turn the preheat function off altogether). Once you have adjusted your settings,
keep pressing the power button until the screen returns to normal.
Alert and protection functions
No atomizer alert: When there is no atomizer installed or if the atomizer is not tightly
screwed onto the battery, the screen will display "No Atomizer Found" when you press the
power button.
Atomizer low alert: When the resistance of the atomizer head is under 0.1 ohms in the VW
mode or lower than 0.05 ohms in the TC mode, the OLED screen will display „Atomizer Low".
Atomizer short circuit protection: In case of an atomizer short circuit, the OLED screen will
display the alert "Atomizer Short".
Temperature alert: If the operating temperature of the device is over 70° C, the device is
shut down automatically and the screen displays the information "Device Too Hot".
english
- 27 -