WISMEC Riccardo Reuleaux RX GEN3 Manuel D'utilisation page 11

english
Resistance range: 0.05 – 1.5 ohm for TC mode
0.1 – 3.5 ohm for VW mode
Temperature range: 100 – 315° C (200 – 600° F)
Maximum charging current: 2 A
Maximum output current: 50 A
Instructions for use
1. Power on and off: Push the back cover open and put three 18650 battery cells (not included)
into the battery compartment. Replace the battery cover. Press the power button button 5
times within 2 seconds to turn the device on or off.
Note:
1. We recommend using high-rate 18650 cells with a discharge current of at least 25 am-
peres. Please note the + and - signs for the positive and negative poles on the inside of
the battery cover.
2. Before use, please adjust the wattage to a proper value according to the atomizer head
you are using.
3. For safety reasons, make sure the battery cells you are using are undamaged and do not
have a torn casing.
- 20 -
2. Vaping: Hold the power button as long as you inhale through the mouthpiece. Release the
power button and exhale.
3. Stealth function: While the device is on, simultaneously press the power button and the
left regulatory button to switch between the "Stealth On" and "Stealth Off" mode. In Stealth
On mode, you can vape with the OLED screen turned off, meaning that no information is
displayed on the screen. If you quickly want to check your settings while in Stealth On mode,
you can tap the power button to display the settings on the screen.
4. Key lock function: While the device is on, simultaneously press both regulatory buttons
to switch between the "Key Lock" and "Key UnLock" mode. While in the Key Lock mode, the
regulatory buttons won't function in order to prevent accidental changings of the settings.
5. Micro USB port functions: The USB port is for charging and upgrading. However, we
recommend you take out the battery cells and charge them with an external charger. Only
use the Micro USB port to update the device.
6. Switch between display modes: When the device is turned off, simultaneously press
both regulatory buttons until the display rotates 180 degrees. Using this function, you can
adjust the reading direction on the screen according to your personal preference.
english
- 21 -