Disassembly And Storage - EXIT Toys 30.93.48.00 Mode D'emploi

6.0 Fill the pool with water
WARNING:
WARNING:
corrected!You shall pull out the drain plug, release the water completely, disassemble
the pool completely,locate the pool on a plane surface, repeat set up instructiion.
WARNING: DO NOT OVERFILL as this could cause the pool to collapse.In times
of heavy rainfall you may need to empty some of the water to ensure the level is
correct.

7.0 Disassembly and storage

WARNING: Do not let your children stand at downfold and face the water outlet
during the drainage. The water current may sweep your children.
WARNING: Pool should be stored at places where it is cool and dry, with no sharp
object surrounded, or no heavy objects lying above, which may cause damage to the
pool.
Step1. I
pump has been disconnected.
Step2.
pool.
Step3. Attach your garden hose to the drainage valve connector, and placing the
other end of the hose in an area where the water can drain safely,such as a storm
end of the hose must be lower in elevation than the pool to ensure complete
drainage.
Step4.
Step5. Attach the drainage valve connector to the drain outlet by turning connector
in a clockwise direction.
Step6. Open the out drain plug on the inside of the pool and the water will begin to
drain immediately.
13
MSP-30100-V03
pool with water. After about 5cm (1-inch) of
wrinkles out of the bottom of the pool.Pull the
outer wall out from the top edge,all around te
-