Warnings To Be Respected - SCS SOFIA M2V5 Manuel D'installation Et D'utilisation

USING THE ELEMENT
COMMUNICATING WITH YOUR VISITOR
When the visitor presses the camera call button, the interior monitor rings and the video switches on.
To pick up press and you may communicate with your visitor. Communication time is a maximum of
seconds. You may adjust the exterior panel's loudspeaker volume by turning the volume button on the back of
the street panel.
VIEWING THE OUTSIDE
When your visitor presses the call button, their image automatically appears on the interior monitor.
To view the outside without pressing the call button, simply press
around 1 minute. To close the image before this press the
ACTIVATING THE LOCK
To activate the electric lock, press
To extend this opening time, move the jumper on the back of the street panel.
3 seconds =
ADJUSTING YOUR MONITOR
To adjust your screen brightness, turn the button
To adjust your monitor's volume, turn the button placed on the bottom of your monitor to the volume you
want.
To adjust your screen's contrast, turn the button
To choose you ring tone, press

WARNINGS TO BE RESPECTED

- This kit must be connected with the 230V/18V 50hz transformer provided.
- Connect up all the elements before you power up the kit
- Leave a minimum of 25 cm between the interior monitor and any other installation.
- Never cover the monitor or transformer.
- Never expose the exterior camera to fire or very bright light.
- Never expose the elements to steam or to a major source of dampness.
- The system can be used in all climates.
- Position the elements on vertical, smooth supports, respecting the explanations in the manual, notably concerning the street
panel's seal.
If not, the warranty will be void.
- Holding down the electric lock's opening button for a long time may damage it.
- The interior monitor must not be installed near a TV set or in a place where the dampness or ambient temperature is too high.
- Never touch the camera with your fingers. Do not open the monitor, the camera or the transformer. This will automatically void the
product warranty.
- Clean glass parts with a soft cloth. Cleaning fluids that may cause corrosion are not recommended.
- Do not cause any impact on the elements as their electronics are fragile.
- No images will be visible on the interior monitor if there is direct light on the camera.
- The image may be altered or cut out slightly when the lock or automatic opener are activated.
- The image may be altered or cut out slightly when motorbikes or bicycles pass near the exterior camera.
. The lock will be open for around 3 seconds. (Default programming).
6 seconds =
and select your ring tone (choice of 15).
9 seconds =
on the bottom of your monitor to the brightness you want.
on the bottom of your monitor to the contrast you want.
ENGLISH
. The image will remain on screen for
button.
4
60
5