Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
CHANGING THE BLADE
Use
Roberts #10-468 (25")
Replacement
Blade. Use the provided Allen wrench to
remove the screws, then hold the blade
at each end and carefully move the blade
out of blade holder.
Note: The flat side of the blade should
face the table.
Warning: Do not put your fingers against
the sharp edge of the blade at any time.
CHANGING THE NYLON BAR
Use the provided Allan wrench to
remove the screws, then hold the nylon
bar and carefully move it out of nylon
bar holder.
Warning: Do not put your fingers against
the sharp edge of the blade at any time.
TRANSPORT
Insert the pin as shown to the hole in the
aluminum eccentric cam and carry the
cutter as shown.
- 3 -
Publicité
Table des Matières
