Changing The Battery; Cleaning, Storage & Disposal - Inventum MT 22 Mode D'emploi

7 | changing the battery
The type 3v cr2032 is already fitted and depending on usage has a
life of around 3000 measurements. When the battery gets weak, the
battery warning symbol appears
temperature. Battery must be replaced. If the thermometer displays the
battery symbol
• remove the screw from the battery cover.
• Open the battery cover and remove the
original battery.
• Take a new cr2032 lithium battery and align it
with the positive terminal (anode) facing
upwards.
• place the battery into the battery
compartment.
• replace the battery cover back tightly.
• Screw the battery cover back tightly.
Used batteries should not go into domestic refuse. you are legally
obliged to dispose of the batteries correctly. Dispose of them through
your electrical dealer or local recycling centre. note: you will find these
symbols on batteries containing toxic substances: pb = battery contains
lead, cd = battery contains cadmium, Hg = battery contains mercury.
The battery in this device does not contain toxic substances.
8 | cLeaning, storage & DisposaL
clean the waterproof sensor tip after every use. Use a clean cloth or
cotton bud which is moistened with disinfectant, alcohol or warm water.
To clean the entire device, use a soft cloth slightly moistened with a mild
soapy solution.
Water must never get into the device. If water gets into the device,
remove the battery immediately. Only use the device again when it's
completely dry.
Do not use any harsh cleaning products. never immerse the device
in water. Only the tip is waterproof.
Always store the thermometer with the cap on in order to protect
the sensor. When putting the cap on the device, align the arrow on the
cap with the arrow on the housing.
The device must not be stored or used at too high or low a temperature
or humidity (see technical specifications), in sunlight, in association with
an electrical current or in dusty locations. Otherwise, inaccuracies can
occur.
If prolonged storage is intended, you should remove the battery.
and 'Lo', the battery must be replaced.
30
. It is still possible to measure the