GB
•
Store the device in a dry place and
out of reach of children. Machines can
be dangerous, if operated by inexperi-
enced persons.
Intended purpose
The device is designed only for the blow-
ing and suction and of dry leaves in private
households and as a hobby device in the
garden. Every other utilization, which is not
explicitly approved in these directions, can
lead to damage to the device and repre-
sents a serious danger to the user.
The device must not be employed in areas
where there is health endangering dusts or
as a wet suction device.
The device is designed for use by adults.
Young people over 16 years may use the
device under supervision only. The use of
the device in the rain or in a humid environ-
ment is forbidden.
The operator or user is responsible for ac-
cidents or damage to other persons or their
property. The manufacturer is not liable for
damage which is caused through inappro-
priate use or incorrect operation.
General description
Scope of delivery - Parts list
Unpack the device and check for complete-
ness.
Dispose of the packaging material properly.
-
engine housing
-
two-piece suction pipe
-
blower pipe
-
2 blower attachments
-
neck strap
-
collection bag with feeder pipe
-
fuel mixing canister
-
mounting hardware
-
service key
-
instructions for use
94
Function description
The garden vacuum has a blowing/vacu-
uming unit for the blowing and suction func-
tions. In blowing mode, you can quickly
blow together fallen leaves or blown them
out of places that are difficult to reach. In
suction mode, the leaves are shredded to
save space, and blown out of the ejector
outlet into the collection bag.
The collection bag is fitted with one-sided
inner lining to prevent fine dust and wet-
ness from penetrating the bag to the out-
side. This lining is located on the left-hand
side of the bag to protect your working
clothes from soiling.
You can vacuum up dry leaves and leaf
parts on the flat with the flat suction nozzle.
The guide rollers at the lower end of the
tube make it easier to guide the tube along
the ground. For the protection of the
user, the equipment is to be operated
only with the two-part blow/suction pipe
fully fitted.
Refer to the following descriptions for in-
structions on how the operating controls
work.
Overview
1a+b fixing lugs for neck strap
2 On/off switch
3 throttle
4 handle
5 engine housing
6 fixing bolt for intake cover
7 intake cover
8 intake opening (not visible)
9 impeller and chopper knives (not
visible)
10 discharge area / discharge
chute
11 spark plug connector
12 bolt for fixing blower pipe/feeder
pipe to collection bag