Installation - Alcad 912-MS Série Manuel D'installation Et Programmation

8- List of technical characteristics
9- Supply cable (120 mm)
2.2 Description of MS-511/512/513/514 modulators
10- Infrared receiver
11- Program switch
12- Program indicator
13- Infrared emitter
14- Audio and video input miniDIN connector
15- Supply connectors
16- Box to indicate output channel
17- Output channel PLL branching indicator
18- Output channel level indicator
19- F connector for RF input signal from previous modulator
20- F connector of RF output signal to next modulator or amplifier
21- Mass connection
22- Short connection bridge (41.5mm)
23- Supply cable (50mm)
24- List of technical characteristics
2.3 Description of the PA-102 amplifier
25- Supply connectors
26- Operating indicator
27- Level regulator of the output signal
28- F-connector for input #1 from the modulators
29- F-connector for input #2 from the modulators
30- Mass connection
31- F-connector for the extension signal input
32- F-connector for output signal testing at -30 dB
33- Signal output F connector
34- Supply cable (50 mm)
35- 75Ω F loads
36- F-connectors
37- List of technical characteristics
3.

INSTALLATION

The diagrams included in the ANNEX show how to carry out the standard
assembly and connections.
Do not connect the supply between the different modules of the unit while
the supply is connected to the mains.
3.1 Unit supply
To supply the unit, it is necessary to connect every module to the MS-011
(cod. 9120029) support framework, which performs the mass
connection.
Serie 912-MS ENG - 25