Operation Details
Now that you and your Kickstand WR1 are better aquatinted, it's time to learn how
quick and easy it is to set up and use. Follow these simple step-by-step instructions and
you'll be up and running (and projecting) in no time!
Connect the Power Adaptor
Carefully plug the supplied power adapter into a standard wall outlet. Then, carefully
plug the power adaptor into the "DC IN" port on the back of the projector.
NOTE: Your Kickstand WR1 can run on its internal battery for up to 2 hours if fully
charged.
Power On/Off
Press and hold the POWER button on your Kickstand WR1 for 3 seconds to power it
on (you must press the power button on the projector, not the remote, to power it on).
The LED indicator will turn blue* when on and a bem wireless startup screen will appear.
After a few moments, the projector will show the main Android media screen (shown
below). To power off your Kickstand WR1 when you're finished using it, press and hold
the POWER button on either the projector or the remote until you see "Powering Off"
appear on the projected image.
*The LED indicator will turn purple when your
Kickstand WR1 is charging while in use.
NOTE: After the projector is unpacked and turned on for the first
time, a slight odor may be emitted from the air vent. This is a normal
result of the manufacturing process. The odor is nontoxic and will
soon disappear with use.
Volume Control
On the remote, repeatedly press the VOLUME UP button to increase the volume
incrementally or hold the VOLUME UP button to steadily increase the volume.
Repeatedly press the VOLUME DOWN button to decrease the volume incrementally or
hold the VOLUME DOWN button to steadily decrease the volume.
12