Setting Up Your Kickstand Wr1 - bem wireless Kickstand WR1 Manuel De L'utilisateur

Setting Up Your Kickstand WR1

Your Kickstand WR1 must be charged before first use or if it has not been used for at
least 7 days. To charge your Kickstand WR1, carefully plug the supplied power adapter
into a standard wall outlet. Then, carefully plug the power adaptor into the "DC IN" port
on the back of the projector. The indicator light on the power button will light red when
charging. The light will turn off when the projector is fully charged (approximately 2
hours).
• When preparing to use your Kickstand WR1, you can place it on just about any flat
surface. Just make sure you keep the following things in mind:
• Make sure the surface is sturdy and secure
• Make sure the surface is even and level for optimal viewing
• Make sure a wall outlet or other power supply is available
NOTE: If using an extension cord, be sure it is properly grounded and does not present
a tripping hazard.
IMPORTANT: Do not look into the lens while the projector is running.
Choosing a "Screen"
• While you can use your Kickstand WR1 to project an image on any surface – go
ahead, hang up a bed sheet in your back yard – here are a few tips to ensure your
presentation, video, or otherwise looks as good as possible:
• Ideally, use a dedicated video projection surface (like a movie screen)
• If projecting onto a wall or similar surface, select one with a light color - preferably
white. Remember, the color of the surface will alter the color of the images you
project on it.
• Avoid projecting onto a glossy or reflective surface (ex: a dry erase board, a glossy
wall)
But remember, the "screen" you choose is a matter of preference. Try projecting an
image on several surfaces to determine what works best for your needs.
10