Starting The Fireplace - Remote; Remote Operation - Manual Mode - Empire Mantis FG28BM Manuel D'utilisation

Starting the Fireplace - Remote

The remote control has two modes for controlling the fireplace's
operation - Manual and Thermostatic. When the remote is in
Manual mode, the fireplace can be turned on and off and the
flame level adjusted manually from the remote. When operating
in Thermostatic mode, the owner sets a desired room tempera-
ture and the fireplace will automatically turn on and off and adjust
the flame level to achieve the set temperature. To operate the
fireplace with the remote control, press the "Mode Select" but-
ton on the fireplace display panel until a double dash " - - " is
displayed.
Note:
When the main power to the fireplace is turned on, as
when following a power outage or at initial setup, the fireplace
will activate in Remote Mode by default.

Remote Operation - Manual Mode

1. Turn the remote on by pressing the remote's power but-
ton. When the remote activates in either Manual (MAN) or
Thermostatic (AUTO) mode the fireplace will automatically
start. If the remote is not in Manual mode, press the remote's
mode button to switch the remote's mode to manual. The
remote display will show "MAN".
MAN
Page 8
2. When the remote is activated, the fireplace display panel will
illuminate and show the flame level set by the remote along
with the remote signal symbol. The fireplace will begin the
start up sequence automatically
MODE
SELECT
REMOTE
MANUAL
OFF
FLAME
LEVEL
DISPLAY
Mantis
BACK LIGHT
Note: The startup sequence takes approximately 1 minute, 15
seconds to complete.
3. Use the adjustment button on the remote to adjust the fire-
place to the desired flame level.
MAN
UP
MANUAL
FLAME LEVEL
ADJUSTMENT
BLOWER
SPEED
DOWN
31794-1-0115