HQ Power HQSM10009 Mode D'emploi page 7

5.8 Timer Mode Parameters
These parameters determine the intervals and wind speed in timer mode.
1. Press <FUNCTION> repeatedly until Interval Set is displayed.
2. Press <UP> or <DOWN> to select the time in seconds from 1 to 200 seconds.
3. Press <FUNCTION> repeatedly until Duration Set is displayed.
4. Press <UP> or <DOWN> to select the time in seconds from 1 to 200 seconds.
5. Press <FUNCTION> repeatedly until Timer Out is displayed.
6. Press <UP> or <DOWN> to set the wind speed from 1 to 100 %.
5.9 Wireless Mode (Optional)
This fan can be controlled remotely from a distance up to 25 m.
1. Press <FUNCTION> repeatedly until Wireless is displayed.
2. Press <UP> or <DOWN> to select On.
3. Press <ON> to switch on the fan; press <OFF> to switch off.
If the remote controller is not working, you may need to pair the wireless controller with the fan. Ensure
the remote controller is switched on. Switch on the fan and the LCD will show as below:
During this time, press and hold button on the remote controller until the display flashes twice to indicate
a match. This can take up to 12 seconds.
Once this has been done, the remote controller frequency will be stored and there will be no need to do
this again.
V. 01 – 13/04/2017
HQSM10009
7 ©Velleman nv