Starting Address; Timer Mode; Manual Mode - HQ Power HQSM10009 Mode D'emploi

5.2 Start-Up
Make sure the switch is on the off position before connecting to the mains.
1. Connect the fan to the mains.
2. Press <VOLUME>.
3. Adjust the winds speed with <UP> or <DOWN>.
5.3 Menu
Refer to the illustrations on page 3 of this manual.
5.4

Starting Address

The HQSM10009 uses one DMX channel in its DMX mode, which defines the highest configurable address
to 512. To select the starting address, do the following:
1. Press <FUNCTION> repeatedly until DMX512 Add. is displayed.
2. Press <UP> or <DOWN> to select a starting address from 1 to 512.
Make sure the starting addresses on the various products do not overlap due
5.5 Setting the Wind Speed
1. Press <FUNCTION> repeatedly until Volume Out is displayed.
2. Press <UP> or <DOWN> to select the desired wind speed from 1 to 100 %.
3. Press <VOLUME> to confirm. Press <VOLUME> again to start the fan.
The setting will be memorized after switching off the fan. To modify the wind
5.6

Timer Mode

In timer mode, the fan will produce wind in pre-configured time intervals defined by the Interval Set
and Duration Set menu options. In addition, the wind speed during the timer mode is set by the
Timer Out menu option. See Timer Mode Parameters below for more details.
1. Press <TIMER>. A countdown of the interval timer is displayed.
2. When the counter reaches zero (0), the fan will start working.
3. The fan working duration is set by the Duration Set menu option.
4. The wind speed is set by the Timer Out menu option.
5. This cycle will repeat itself until you press <TIMER> again or until the fan is switched off.
5.7

Manual Mode

In manual mode, the fan will produce wind for as long as <MANUAL> is pressed. The wind speed will be
at 100 %.
1. Press <MANUAL>. This mode will continue until you release <MANUAL> or until the fan is
switched off.
V. 01 – 13/04/2017
HQSM10009
REMARK
to the personality setting.
REMARK
speed, simply repeat the steps above.
6 ©Velleman nv