Safety Instructions - Vasco GK-EL Manuel D'utilisation Et D'installation

SAFETY INSTRUCTIONS

The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction. Children being supervised not to play with
the appliance
OPERATION
[ + ] Button
Button [Prog]
[On/stand-by]
Button
[ - ] Button
1. POWER ON/STAND-BY
Press the [On/Stand-by] key to turn on the device or to enter the "Stand-by" mode. When activated, the bottom part of the
display shows the current time, while the configured operative mode and the temperature are shown in the upper part. When in
"Stand-by" mode current time, day of the week and the message: " Stb" are displayed. When the device goes into "Stand-by"
mode it beeps twice for 0.5s. When the device is activated it beeps once for 1s.
2. "COMFORT" and "ECO" MODES
Two different levels of temperature can be set:
-"COMFORT" temperature: It is the temperature used for "Auto" and "Comfort" modes.
-"ECO" temperature: It is the temperature used for the "Auto" and "Eco" modes.
The desired temperature can be set pressing the [+] and [-] buttons. The range of configurable temperature is 7°C - 32°C.
Remark:
The temperature of "Eco" mode must be below to the "Comfort" mode temperature. For this reason the "Eco" mode temperature
can be set to a value between 7°C and the (configured "Comfort" mode temperature - 0.5°C). The temperature of "Comfort"
mode can be configured in the whole range (Eco temperature + 0.5°C) - 32°C.
3. OPERATING MODES
Press the [PROG] button to select the desired operative mode. An icon on the display indicates the selected operating mode,
according to the following table:
FIL-PILOTE-MODE (only for France)
COMFORT MODE
The "Comfort" stably maintains the room temperature to a selected value. To set this operative mode:
-Press the [Prog] button until the display shows the "Comfort" icon
-Set the desired temperature through [+] and [-] buttons and wait until the displayed temperature stops blinking.
ECO MODE
The "Eco" mode sets a value of temperature below the "Comfort" temperature value.
It is suggested to set this operating mode during the night or when the room is not occupied for 2 or more hours.
-Press the [Prog] button until the display shows the "Eco" icon
-Set the desired temperature through [+] and [-] buttons and wait until the displayed temperature stops blinking.
ANTIFREEZE MODE
In "Antifreeze" mode the temperature is fixed to 7°C. The device activates the heating element when the room temperature falls
below 7°C. It is suggested to set this operating mode when the room is not occupied for several days. Press the [Prog] button
until the display shows the "Antifreeze" icon
BOOST
The "Boost" can be used to quickly warm up the room.
-Press the [Prog] button until the display shows the "2h" icon.
The device is activated at the maximum power for 2 hours, up to a maximum room temperature of 32°C. The "Boost" mode is
automatically deactivated after a period of 2 hours and the device returns to the operative mode previously set. The user can
switch to another operative mode at any time by simply pressing the [PROG] button.
Fil-Pilote Comfort
EN
Indicator of active
heating element
Comfort/Eco bar
(Auto mode)
Operating mode:
- Comfort
- Eco
- Antifreeze
- Boost
- Auto
Open window
detection
Eco Antifreeze Boost
24h indicator
Configured
temperature
Time
Day of
Key-lock
the week
Auto