Hilti SR 30-A36 Mode D'emploi page 16

1. Remove the battery.
2. Remove the saw blade. → page 9
3. Press the red release button for the contact shoe on the underside of the reciprocating saw.
4. Pull the contact shoe out.
5. Press the red release button for the contact shoe on the underside of the reciprocating saw.
6. Insert the lightly greased contact shoe fully into the guide.
7. Check that the contact shoe has engaged.
8 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
9.1 The reciprocating saw is not in working order
Trouble or fault
The tool doesn't start.
The saw blade cannot be
removed from the chuck.
9.2 The reciprocating saw is in working order
Trouble or fault
The tool does not develop full
power.
10 English
Printed: 19.09.2019 | Doc-Nr: PUB / 5391395 / 000 / 03
Possible cause
The battery is not correctly in-
serted.
The battery is empty.
The transport lock is engaged.
The locking lever was not pushed
as far as it will go.
Chuck clogged by residues from
sawing operations.
Possible cause
The control switch is not fully
pressed
The battery is discharged
Action to be taken
▶ Push the battery in until it
engages with a click.
▶ Charge the battery.
▶ Disengage the transport lock.
▶ Push the locking lever as far as
it will go and remove the saw
blade.
▶ Remove the residues from
sawing operations and regularly
clean the chuck from the
outside. Care of the power tool.
→ page 9
Action to be taken
▶ Press the control switch fully.
▶ Change the battery and charge
the empty battery.
2186518
*2186518*