SPX Johnson Pump AquaT Série Manuel D'utilisation page 14

Silent electric marin toilet
You need
• Stainless steel bolts: 3 pcs, 8 mm (5/16") diameter of length to suit the
thickness of the mounting surface.
• Stainless steel nuts: 3 pcs preferably self-locking. If you do not use self-
locking nuts you need to add locking compound on the screws-/nuts.
• Stainless steel washers: 3 pcs.
• Drill: Diameter 9 mm.
• Silicone sealant, white.
If you do not use self-locking nuts, you will need some nutlocking com-
pound.
1. Put the toilet in the selected position. Using the holes in the base
as a guide, mark the positions for the 3 bolt holes on the mounting
surface. Remove the toilet and drill 3 vertical holes, with a diameter of 9
mm, through the mounting surface.
2. Apply the white silicone sealant to the outer rim of the bottom base.
3. Put the toilets on its place and tighten the fastenings securely. If you are
not using self-locking nuts, use nutlocking compound.
4. Use the sealant around the base, towards the floor.
Mounting
Premium marine toilets
Necessary items for a successful mounting are attached in a plastic bag in
the toilet box.
This assembly kit consists of:
Assembly bracket: 2 pcs
Screw Ø6,2x50: 2 pcs
Screw Ø4,7x40: 2 pcs
Washer: 2 pcs
Plastic sleeve: 2 pcs
Screw cover, chrome: 2 pcs
DETAIL A
Original instructions
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Secure the toilet by using the Ø 4,7 mm screws. As the bracket has a
11. Put the screw cover on the screw head.
12. Use the sealant around the base, towards the floor.
A
14
Put the toilet in the selected position.
Using the two holes in the toilet and the outer line of the toilet as guide,
mark the location and outer line of the bowl of the holes in the toilet.
Remove the bowl.
Re-draw a new parallel line approximately 14-15 mm inside of the line
you did in step 2.
Put the assembly bracket on the floor, with the slot horizontal.
Mark the middle position of the slot and drill a Ø5 mm hole for each
bracket.
Tighten the bracket by using the enclosed Ø 6,2mm screws.
(Ensure that they are not to long for your installation).
Now we recommend finishing the rest of the installation (plumbing,
electric, etc.)
Put the toilet back in the selected place.
Put the one plastic sleeve in each assembly hole on the toilet.
lot of small holes, you can make a small final position adjustment.
C
B
DETAIL B
DETAIL C