Safety Rules For Laser Lights; Circular Saw Safety - GMC SYT210 Manuel

d. Store idle power tools out of the reach of children and do
not allow persons unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding of
moving parts, breakage of parts and any other condition that
may affect the power tool's operation. If damaged, have the
power tool repaired before use. Many accidents are caused by
poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained cutting
GB
tools with sharp cutting edges are
less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc. in accordance
with these instructions, taking into account the working
conditions and the work to be performed. Use of the power
tool for operations different from those intended could result in a
hazardous situation.
5. SERVICE
a. Have your power tool serviced by a qualified repair person
using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
Product Wave Length: 650nm,
Output Power: ≤1mW
EN 60825-1:1994+A2:2001+A1:2002

Safety Rules for Laser Lights

The laser system used in this tool does not normally present an
optical hazard, however it is important to follow the safety rules below:
• Do not switch on the laser light until the tool is ready to cut
• Do not direct the laser light towards yourself or other persons
• Do not point the laser at reflective sheet material as the surface
could direct the beam back at the operator or other persons in the
vicinity
• Changes to or replacement of the laser light assembly should only
be carried out by the manufacturer or an authorised agent
• Maintain the laser in accordance with the manufacturer's
instructions
CAUTION: Failure to follow safety rules may result in flash blindness
and/or hazardous radiation exposure

Circular Saw Safety

WARNINGS. Before connecting a tool to a power source (mains
switch power point receptacle, outlet, etc.) be sure that the voltage
supply is the same as that specified on the nameplate of the tool. A
power source with a voltage greater than that specified for the tool can
result in serious injury to the user, and damage to the tool. If in doubt,
do not plug in the tool. Using a power source with a voltage less than
the nameplate rating is harmful to the motor.
• Do not allow anyone under the age of 18 years to operate this
saw
• When operating the saw, use safety equipment including safety
goggles or shield, ear protection, dust mask and protective
clothing including safety gloves
• Always use recommended blades with correct size and shape of
arbor holes e.g. diamond or round. Blades that do not match the
mounting hardware of the saw will run eccentrically, causing loss
of control
• Whenever possible, use a vacuum dust extraction system to
control dust/waste
• Power tools must always be held by the insulated gripping
surfaces when performing an operation, ensuring protection if
the cutting tool makes contact with its own cord or hidden wiring.
Contact with a 'live' wire will make exposed metal parts of the
power tool 'live' and shock the operator if the insulated gripping
surfaces are not used
• Ensure hands are away from the cutting area and blade. Keep
one hand on auxiliary handle, or motor housing. If both hands are
holding the tool they cannot be cut by the blade
• Do not attempt to cut material thicker than detailed in the
Specifications section of this manual
• Adjust the cutting depth to the thickness of the workpiece i.e. less
than a full tooth of the blade should be visible below the workpiece
6