Maintenance And Care; Contact Information - CALIMA 46005 Manuel De L'opérateur

5.2 HOSE ATTACHMENT
First, set the locking valve to the ‚closed' position, Figure 2. Place your hose on the
hose attachment (Position 5 in the overview) of the mop. When washing, set the
locking valve to the ‚open' position.
5.3 ADJUSTING THE LENGTH OF THE TELESCOPE
To adjust the length of the telescope, loosen the cap nut of the telescope length
adjuster (Position 3 in the overview). Pull the telescopic rod out and refasten the
cap nut, Figure 3.
5.4 USE WITHOUT TELESCOPIC ROD
To clean smaller surfaces, you can remove the telescopic rod from the washing head. To do this, hold the washing head in one hand and unscrew
the telescopic rod with the other, Figure 4.

6. MAINTENANCE AND CARE

• After washing, rinse out any remaining cleaning products completely.
• Open the locking valve and let the water run out. Any remaining water can damage the mop in the event of frost.
• Let the microfibre mop dry out completely before putting it away until needed again.
• Never leave the mop standing on the fringe/bristle end, hang it up instead.
• The microfibre casing is washable.
7. NOTES REGARDING ENVIRONMENTAL PROTECTION
Dispose of the mop with telescopic rod in the bin or local collection points.

8. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Deutschland
Figure 4: Remove telescopic rod
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
Figure 2: Locking valve
Figure 3: Adjust length
info@eal-vertrieb.com
www.eal-vertrieb.com
5