Reattaching The Refrigerator Doors - Samsung RF263TE Série Manuel D'utilisation

2.
Disconnect two connector (
door. To remove the water coupler from the
hinge, twist and pull it from the hinge. Remove
the water line ( 3 ) while pressing the marked
part ( 4 ) of the water line coupler.
If a red clip is on the coupler, it must be
removed before removing the tube.
CAUTION
2
Red Clip
(1/4")
3
4
3. Pull and remove the hinge lever (
the ground screw ( 6 ) attached to the upper
left door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges
( 7 ).
5
7
4. Lift the door straight up to remove.
5. Remove the screw (
lower left and right door hinges with a philips
screwdriver (+). Remove the 2 hex head bolts
( 9 ) attached to the lower left and right door
hinges with an allen wrench (3/16"). Remove
the lower left and right door hinges ( 10 ).
08_ setting up
DA68-02601A(EN+FR+ES)-0.2.indb 8
2 ) on the left side
5 ) . Remove
6
8 ) attached to the
10
8
9
Allen wrench
REATTAChING ThE
REFRIGERATOR DOORS
To reattach the fridge doors after you have moved
the fridge to its final location, assemble parts in
reverse order.
1. The Water Line must be fully Inserted to the
center of transparent coupler to prevent water
leakage from the dispenser.
2. Insert
the clip in the install pack and check that it
holds the line firmly.
clip A (1/4")
(6.35mm)
DISASSEMBLE ThE FLEx DOOR
1.
Take out the upper drawer by lifting it up.
2. Take out the lower basket (
basket up from the rail system.
3. Press the fixing hook of rail system.
Center of transparent
coupler
1 ) by lifting the
1
2012.3.31 9:49:38 AM