822_949_466 TG340_AEG.book Seite 6 Freitag, 8. Mai 2009 7:22 19
g
Preparing the table grill
0
Insert drip tray (2) in base frame (1).
Inserting the heater plate (4) in the
base frame (1).
Apply a little cooking oil to the surface
of the heater plate each time before
use with the aid of kitchen paper for
better non-stick properties.
Insert the thermostat with mains cable
(3) fully in the socket on the appliance.
The thermostat can only be fitted
when the heater plate (4) is in the cor-
rect location in the base (1).
Working with the table
0
grill
Connect the mains cable (3) to the
socket.
Turn the thermostat (3) to the desired
setting (1 to 5).
1 = lowest temperature
5 = highest temperature
The operating lamp (3/a) on the ther-
3
mostat is on while the grill is heating
up. When the temperature is reached,
heating takes place at intervals to
maintain the temperature constant.
To switch off the appliance, turn the
thermostat to "OFF".
Practical tips
• The grill bars (4/c) are ideal for the
preparation of meat, fish and poultry.
Fat and juice can fall into the drip tray
through the grill webs. This ensures a
healthy, low-fat preparation.
• The frying surface (4/b) is ideal for
example for the preparation of eggs,
ham, mushrooms, tomatoes, onions,
etc. It is also very well suited for keep-
ing food warm.
6
ELX12837_Tina_tablegrill_AEG.indd 17
Cleaning and care
0
Remove the mains plug from the
socket.
Allow the appliance to cool down.
Disassemble the appliance. The heater
plate can only be removed from the
base frame after the thermostat has
been removed.
The heater plate can be cleaned in the
dishwasher or manually.
Thermostat, drip tray and base frame
should be cleaned with a damp cloth
(not safe for dishwasher).
Dry all parts thoroughly before reas-
sembling the appliance.
Note that water must not penetrate
1
inside the thermostat under any cir-
cumstances!
Never clean under running water or
even in rinsing water.
Storage
It is best to store the table grill assem-
bled.
Technical data
Mains voltage:
Power consumption:
Disposal
Packaging material
2
The packaging materials are environ-
mentally friendly and can be recycled.
The plastic components are identified
by markings, e.g. >PE<, >PS<, etc.
Please dispose of the packaging mate-
rials in the appropriate container at
the community waste disposal facili-
ties.
230 V
2200 W
17
2009-08-25 16:10:29