Panasonic WV-CS954 Mode D'emploi page 16

5. Attach the safety wire for securing the camera to
the camera mounting base.
Pull on the safety wire to make sure its ring is
securely connected to the camera mounting base
hook.
If the dust protection sheet that comes with the
camera is affixed to the camera mounting base,
remove it before performing the above step.
Safety
wire ring
Note: The safety wire is designed to allow the
camera to hang from it. Do not apply force greater
than the weight of the camera to the wire.
6. Install the camera onto the camera mounting base.
Aligning with the camera mounting base, press
down on the camera as far as it will go and rotate in
the direction indicated by the arrow.
7. Use the fixing screw you removed in step 1 to
secure the camera to the camera mounting base.
8. Check the installation.
• Is the camera is level and installed securely?
• Is the camera free of looseness?
• Does the fixed part of the camera remain in place
when you try to rotate it?
Camera
Rotate
Camera
Mounting
Base
9. Separate the two parts of the decorative cover
(comes with camera).
Press upwards on the decorative cover at the
points marked
illustration below) to unhook the two parts from
each other.
* When removing the decorative cover, the direction
to press ( ) is shown on the side of the decorative
cover.
Back
Caution: Pressing up on the wrong side of the
decorative cover can damage it.
10. Put the two pieces of the decorative cover on the
left and right side of the camera, and hook them
together.
Align the hooks and press the piece indicated by
the arrow in the illustration below into the other
piece.
Back
11. Slide the decorative cover up to the ceiling.
• In the case of a top cable exit configuration, slide
the decorative cover straight up and press it firmly
against the ceiling.
• In the case of a side cable exit configuration, align
the cutout in the decorative cover with the cables
as you slide it up, and press it firmly against the
ceiling.
Top Cable Exit
Configuration
-16-
(indicated by the arrows, in the
Unhook
Fix securely
Press
Press
Fix securely
Hold Hold
securely securely
Align
hook
Press
Press
Side Cable Exit
Configuration
Align with
cutout