Cleaning & Maintenance; Troubleshooting - Inventum VK561 Mode D'emploi

7
cleaning & maintenance
Before cleaning the appliance, always unplug the appliance.
Clean the interior of the appliance. Use warm water and a neutral detergent to prevent any bad smells occurring. After cleaning,
rinse the interior with clean water and rub dry. Leave the appliance to dry for 1 to 2 hours. Simply remove the shelves, drawer and
door compartments to clean them by hand. Do not clean the interior accessories in the dishwasher.
Clean the outside of the appliance and the gasket with a soft moist cloth.
For areas that are difficult to clean in the appliance, such as narrow gaps or corners, it is recommended to wipe them regularly with
a soft rag, soft brush, etc. When necessary use some auxiliary tools, such as thin sticks (tooth picks), to ensure no contamination
can accumulate in these areas.
We recommend that you dust the back of the appliance and on the floor with a cloth or vacuum cleaner once a year in order to
maintain a good output and low energy consumption.
Do not use hard brushes, cleaning steel wire balls, wire brushes, abrasives, such as toothpastes, organic solvents (such as alcohol,
acetone, oils, etc.), boiling water, acid or alkaline items to clean the refrigerator considering that this may damage the fridge
surface and interior. Boiling water and benzene may deform or damage plastic parts.
8

troubleshooting

Problem
Appliance is not functioning;
indicator light does not work
Temperature inside the
freezer is too high or too low
Appliance is excessively
noisy
The lid does not close
properly
The compressor runs too
long
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
24
• English
Cause
Appliance is not plugged in
Thermostat has been set
incorrectly
Air circulation vents are blocked
Has the appliance been installed
correctly?
Are the pipes at the back touching
or vibrating?
Is the freezer loaded too full?
It is normal that the freezer
operates for a longer time in the
summer.
There is a thick frost layer inside
the freezer.
Solution
Plug the appliance in the socket
Set the thermostat correctly
Clean the ventilation openings
Check the installation
Check it and move the appliance forwards
Check the content of the freezer.
Do not place too much food at once in the freezer;
Do not place warm food in the freezer, wait for it to cool
down;
Do not open the lid too often.
Defrost and clean the freezer.