Before You Start; Checking What's In The Box; Inserting The Batteries - TAD -C2000 Manuel Du Propriétaire

BEFORE YOU START

Checking what's in the box

Please check that you have received the following supplied accessories in the accessory box.
Remote control x 1
'
AMP DISP

ANALOG
1 2 3
4
DIGITAL
1 2 USB
RESET
VOLUME
+
–
MUTE
TAD-C2000

Inserting the batteries

Replace the batteries when you notice a reduction in the operating range of the remote control unit.
CAUTION
Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following precautions:
Do not mix new and old batteries, or different brands of batteries.
'
Insert the plus and minus sides of the batteries properly according to the marks in the battery case.
'
Use type AAA (SUM-4, R03) Manganese or Alkaline dry cell batteries.
'
When not using the remote control for a long period of time (1 month or more), remove the batteries from the remote
'
control, to prevent damage from inadvertent leakage. If battery leakage occurs, wipe up any battery exudate from inside
the case and replace with new fresh batteries.
When disposing of used batteries, please comply with
governmental regulations or environmental public
institution's rules that apply in your country/area.
8
AAA/IEC R03 dry cell
'
batteries x 2
Power cord (U.S. model)
'
1
D3-4-2-3-1_B1_En
Operating Instructions (this document)
'
Power cord (Europe, Asia model)
'
2 pins plug type (For use in
Europe except in the UK)
2 3
WARNING
Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater. This
can cause batteries to leak, overheat, explode or catch fire. It
can also reduce the life or performance of batteries.
3 pins plug type (For use
in the UK, Singapore,
Malaysia, Hong Kong)
D3-4-2-3-3_A1_En