Remote Control - TAD -C2000 Manuel Du Propriétaire

Remote control

AMP DISP
1

ANALOG
1 2 3
2
4
DIGITAL
1 2 USB
3
RESET
VOLUME
+
4
–
5
MUTE
TAD-C2000
Remote control operating range
When using the remote control unit to operate the TAD-C2000, point the remote
control at the main unit's remote sensor within the ranges shown in the accompanying
illustration.
The remote control may not operate properly if obstructions exist between the
'
remote control unit and the remote sensor, or if the angle between the remote
control and the remote sensor is poor.
Malfunctions may occur if the TAD-C2000 is used nearby other appliances that emit
'
infrared light, or if remote control units for other devices utilizing infrared light are used nearby. Alternately, using this
remote control unit near other appliances that also utilize infrared light may cause those appliances to malfunction.
Replace the batteries when you notice a reduction in the operating range of the remote control unit.
'
The remote control may not operate correctly if strong sunlight or light from fluorescent lamps is allowed to strike the
'
remote sensor directly. In such cases, change the installation location, or remove the fluorescent lamps to a more
distant location.
1 AMP  button
6
Use to switch power to ON/Standby.
2 ANALOG buttons
Use to select to analog inputs.
1: Select LINE 1.
2: Select LINE 2.
3: Select LINE 3.
4: Select LINE 4.
3 DIGITAL buttons
Use to select digital inputs.
1: Select D1:XLR.
2: Select D2:COAX.
USB: Select D3:USB. Press this button when a USB cable is used to connect
amplifier to a computer.
RESET: Press this button to correct faulty music playback when a USB cable is
used to connect amplifier to a computer.
4 VOLUME (+/−) buttons
Press + button to raise sound volume, and – button to lower volume.
5 MUTE button
Press to turn off sound.
6 DISP button
Press to switch amplifier display ON/OFF.
TAD-C2000
11