Publicité
Les langues disponibles
Les langues disponibles
English
Material with item n°:
10.
1x Tool holder
1x Tool holder's plate
20.
40.
1x Centering tool
50.
4x Screw M5x20
60.
3x Screw M3x25
70.
3x Screw M6x25
with
3x Wascher M6
80.
1x Fork key
Note:
All fixing screws shall be tightened to the torques specified
in the table below.
Standard quality:
8.8
Recommended torque for screws and bolts
Tightening torque [Nm]
Diameter
Class 5.8
M2
0.22
M3
0.77
M4
1.8
M5
3.6
M6
6.1
M8
15
Instructions :
Centre the Tool holder's plate N°20 with the centring
1.
tool N°40 and screw the 4 screws N°50 at the
indicated torque.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
0400-SC016-RA00H0-2D01
0400-SC016-RA0000-2D01
873-728-03
873-019-186
SBB5-20
D912-M3x25
D912-M6x25
D125 A-M6
BRC42121017
Class 8.8
Class 10.9
Class 12.9
0.35
0.49
0.58
1.2
1.7
2.1
2.9
4
4.9
5.7
8.1
9.7
9.8
14
17
24
33
40
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Mode d'emploi
Validation : 22.03.2022
2.
Insert the tool holder N°10 in the tool post N°30 and
tighten the 6 screws N°60 and N°70 at the indicated
torque.
3.
Settle the offsets of 4 positions.
4.
During the assembly or the dismantling of your tools
of cup, to block the brooch on dishes planned for that
purpose, by using the key fork N°80.
5.
The diameter of tail of a tool of cup never has to have
a difference furthermore of 0.4mm regarding the
diameter of the crowbar. Example: Ø of crowbar
9.5mm - Ø tail 9.1 minimum.
6.
To set the machine's parameters:
a.
b.
c.
MARK:
-
never use the chuck with empty positions. Use
the supplied corks.
-
Do not use the tool holder without the coolant.
Garant :
BT
RA00H0-2D01 Mode
Start the coolant for 1 min.
Set the tool holder with a max speed 3000
rpm during 30 sec.
Repeat a. if necessary.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email :
office@pcm.ch
Document :
0400-SC016-
d'emploi.docx
Page : 2 de 3
Publicité
