Merrithew Halo Trainer Plus Mode D'emploi page 6

ASSEMBLY INSTRUCTIONS
Assembling the Halo Trainer Plus:
Reverse Position
STOP! Read these instructions completely before beginning.
Place all parts from the box in a cleared area and position them on the floor in front of you.
w
Remove all packing materials from the area and place them back into the box.
w
Do not dispose of the packing materials until assembly is completed.
To prevent unsafe or improper use, please read each step carefully before beginning.
w
Reverse Standard Position Assembly
This position is not to be used with a Stability Ball .
1. From Standard Position (Long Handles Out).
2. Locate and depress the finger tab [3] on one Halo frame
connector [4] to separate one long bar.
3. Repeat on the other Halo frame connector. Remove long bar
completely and set aside.
4. On remaining assembly, grasp the long bar, depress the finger
tab on the Halo frame connector and spin short handle 180°.
5. Repeat on the other side. Listen for the click to ensure short
handles are locked in place.
1
4
7
6 Halo Trainer Plus Owner's Manual
®
6. Lay Halo on its side.
7. Partially insert long bar into the two connectors. The Halo
Trainer Plus and Merrithew logos will now be facing each other.
8. You may need to press the spring buttons to allow the long
bar to slide into the connectors. Do this cautiously to not pinch
your fingers. Once both spring buttons are partially inserted,
apply firm pressure to the long bar to fully insert it. Test that
the all connectors are locked by gently pulling on each side of
the connectors.
9. Halo is now in Reverse Position (Long Handles In).
2
5
8
3
6
9