Table des Matières
Publicité
ASSEMBLY INSTRUCTIONS
Assembling the Halo Trainer Plus:
Standard Position
STOP! Read these instructions completely before beginning.
Place all parts from the box in a cleared area and position them on the floor in front of you.
w
Remove all packing materials from the area and place them back into the box.
w
Do not dispose of the packing materials until assembly is completed.
To prevent unsafe or improper use, please read each step carefully before beginning.
w
Standard Position Assembly to fit 55 cm / 22" Stability Ball.
1. Place the long bar [2] assemblies down with the convex sides
facing outward, so they create a circular shape on the floor.
2. Depress both spring buttons [10] on one end of a long bar [2]
and slide the connector [4] at the end of the short handle [1] over
the bar until the finger tabs [3] click into the spring buttons [10].
Repeat with the other end of the short handle, sliding connector
over one end of the other long bar, and then with the opposite
short handle.
When fully assembled and resting on the long bars, from
w
top view, the Halo Trainer Plus should form a circle on the
floor as shown in Fig. B, and should sit stable on the floor.
When using the Halo Trainer Plus in conjunction with a
w
55 cm / 22" Stability Ball, firmly mount the Halo Trainer
Plus to the Stability Ball as shown in Fig. C so the long bars
conform snuggly to the Ball approximately one-third (1/3)
from the top. If the long bars are above or below this position,
check the inflation of your Stability Ball.
B
STEP 2
STEP 1
C
5
Publicité
Table des Matières
