Resistance Measurement; Voltage Measurement - Seaward PV100 Notice D'utilisation

Solar Installation PV100

5.3.2 Resistance measurement

5.3.3 Voltage measurement

To make a single measurement:
1. Connect the red and black test leads as shown.
2. Press the Rpe key.
3. The resistance between the test probes is
displayed.
To make a continuous measurement:
1.
Connect the red and black test leads as shown.
2.
Press and hold the Rpe key until the lock icon
appears on the LCD.
3.
The resistance between the test probes is
displayed.
4.
Press the Rpe key to terminate the continuous
measurement mode.
1.
Connect the red and black test probes to a
voltage source
2.
The PV100 will automatically measure the
voltage between the probes.
3.
The polarity of the voltage is shown using the
icon next to the Rpe icon
4.
If the measured voltage is AC, alternating + and –
is shown.
- 10 -
Operating Instructions