Lewmar Pro/Fish Série Manuel D'installation page 11

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
6.2 Manual anchor recovery
WARNING! Isolate (Turn off) the
windlass using circuit breaker / isolator.
1
1. Ensure capstan drive cap is tight so the clutch is locked.
2. Release any anchor locks and when safe insert the Lewmar wrench or a standard 12mm (1/2") drive rachet into
the socket end of the driveshaft on the opposite site of the windlass to the gypsy.
3. Using the wrench, turn the driveshaft clockwise to retrieve the anchor.
WARNING! Always remove
wrench handle after use
4. Once anchor is retrieved, remove the wrench handle and ensure it is adequately secured to an independent
strong point.
6.3 Power up/down
6.3a - Pro-Fish
1
To release anchor:
1. Check unit is not in manual mode and plunger is disengaged/up position.
2. Release any anchor locks.
3. Engage the circuit breaker/isolator.
When releasing the anchor, press DOWN button for 2 seconds until the anchor is under freefall. If the clutch
was left in a locked position the anchor will move almost immediately, if unlocked it could take several seconds
to fully re-engage the internal clutch.
NOTE: Pressing the DOWN button for over 5 seconds will result in a longer clutch re-engagement time during
the next UP command).
If using a rope/chain rode, motor astern to create the desired scope. Once scope has been created press the
UP button continuously until freefall stops. It normally takes several seconds to fully re-engage the internal
clutch mechanism, locking the windlass.
NOTE: Failure to lock the windlass clutch could result in rope/chain creeping out.
To retrieve anchor:
4. Press the UP button continuously to retrieve the anchor.
WARNING! Trapping, crushing or
entanglement danger whiIst operating
windlass manually or under power
2
2
ON
Lewmar Pro-Series/Fish windlass ref B10414 iss.1
3
3
ON
4
4
|
11

Publicité

Table des Matières
loading

Table des Matières