Safety Information - VWR 700-0450 Manuel D'instructions

Warning
Federal Communications Commission Advisory
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at their expense.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

Safety Information

Avoiding Electrical Shock
The Power Source 300V Hi Amperage Power Supply produces an output of up to 300
volts which are electrically isolated from ground to reduce the risk of electrical shock
to the user. Please follow the guidelines below, and read this manual in it's entirety to
ensure safe operation of the unit.
The 300V Hi Amperage Power Supply has been designed for use with electrophoresis
gel box systems with shielded banana plugs thus minimizing any potential shock
hazard to the user. Always use gel box systems that are compatible with the Power
Supply, have been designed for your specific applications, and are suitable for the
voltage and current range of the Power Supply. Always use gel box systems that
have safety lids to prevent accidental electric shocks to the user. VWR recommends
against the use of gel box systems and/or power leads that have unshielded banana
plugs.
To avoid electrical shock:
1.
NEVER connect or disconnect wire leads from the power jacks when the red
indicator light at the Start/Stop key is on or when "RUNNING" is displayed on the
screen.
2. WAIT at least 5 seconds after stopping a run before handling output leads or
connected apparatus.
3. ALWAYS make sure that hands, work area, and instruments are clean and dry
before making any connections or operating the power supply.
4.
ONLY connect the power supply to a properly grounded AC outlet.
1