Safety Regulations; Items Supplied - Pattfield Ergo Tools E-HKS 1600-Laser Mode D'emploi D'origine

Anleitung_E_HKS_1600_Laser_SPK7__ 27.02.13 09:54 Seite 13
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
Important! Laser radiation
Do not look into the beam
Laser class 2
VORSICHT ! - LASERSTRAHLUNG !
Nicht in den Strahl blicken!
Laserspezifikation
Laser Klasse 2;
Ï: 650 nm; P : ≤ 1 mW
0
nach EN 60825-1: 2007
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open the laser module.
When the machine is not going to be used for an
extended period of time, the batteries should be
removed.
Use of the batteries
Ensure that the ON/OFF switch for the laser is
set to its "0" position before you fit the
batteries.
Inserting the batteries when the laser is switched
on can cause accidents.
If the tool is not used correctly the batteries
may leak. Avoid contact with the battery fluid.
If you come into contact with battery fluid,
clean the affected body part with running
water. If you get battery fluid in your eyes,
seek immediate medical assistance.
Leaked battery fluid can cause skin irritation and
acid burns.
2. Layout / Items supplied (Fig. 1a/1b)
2.1 Layout
1. Handle
2. ON/OFF switch
3. Locking button for ON/OFF switch
4. Locking lever for cutting depth setting
5. Power cable
6. Soleplate
7. Locking lever for miter setting
8. Locking screw for parallel stop
9. Scale for miter angle
10. Additional handle
11. Spindle lock
12. Saw blade
13. Laser ON/OFF switch
14. Battery compartment cover
15. Laser
16. Parallel stop
17. Screw for securing the saw blade
18. Flange
19. Swing guard hood
20. Lever for swing guard hood
21. Guard hood
22. Splitter
23. Chip extractor connector

2.2 Items supplied

Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
GB
13