Installation And Connection; Installation Instruction - Franke FMW 250 CS2 G XS Mode D'emploi

Installation and connection

1. This appliance has been designed exclusively for domestic use.
2. The oven in question has been designed as an integrated appliance.
3. Observe the special installation instructions.
4. The appliance can be installed in a wall-mounted cupboard in heat-resistant material, with a
width of 60 cm (at least 55 cm deep and at least 85 cm from the floor).
5. The appliance is fitted with a plug and simply needs to be connected to a suitably installed
socket, which in turn must be earthed.
6. The mains voltage must correspond to the voltage specified on the appliance rating plate.
7. Socket installation and power cord replacement procedures must be carried out exclusively by a
specialised electrician. If, after installation, the plug is no longer accessible, fit an omnipolar
disconnect switch with a contact opening gap of at least 3 mm.
8. Use of adapters, multi-socket power strips and extension cables is prohibited. Any current
overloads could, in fact, cause a fire.
Please Read the Manual Carefully Before Installation
Please Note
Electrical connection
The oven is fitted with a plug and must be only connected to a properly installed earthed
socket. In accordance with the appropriate regulations, the socket must only be installed and
the connecting cable must only be replaced by a qualified electrician.
If the plug is no longer accessible following installation and all-pole isolating switch must
be present on the installation side with a contact gap at least 3mm.
The built-in cabinet shall not have a rear wall behind the appliance.
Minimum installation height is 85cm.
Do not cover ventilation slots and air intake points.
Accessible surfaces can
become very hot during use.

Installation Instruction

40