Mitsubishi Electric Mr.SLIM PLA-A EA7 Série Manuel D'installation page 17

9. Installing the grille
A
B
C
E
F
D
Fig. 9-6
< The grille temporary installed >
C
D
Fig. 9-7
C
D
B
A
B
A
C
E
F
G
Fig. 9-9
Position 1
Prohibited installation
position
Drain pipe
A Main unit
B Corner of drain pipe
C Claw on the main unit
D Grille 1
E Hole on the grille
F Hook for temporary installation
G Screw with captive washer
H Ceiling surface
J No gap
K Adjust the nut of main unit using a wrench,
etc.
J
A
H
D
G
K
A Clamp of the main unit
B Electrical box
C Lead wires of the grille
D
A CN4Z on the controller board
B CN5Y on the controller board
C Lead wire of i-see Sensor corner panel
D Clamp
E Hole of grille (Pass the lead wire.)
F Screw 3
G i-see Sensor corner panel 4
Position 2
Position 3
Refrigerant pipe
and put them together temporarily by hanging the hook of the grille to the claw of
the main unit.
Note:
Make sure there is no gap between the main unit and the grille or between the
grille and the ceiling surface. (Fig. 9-7)
If there is a gap between the grille and the ceiling:
With the grille attached, slightly adjust the installation height of the main unit and
clear the gap.
Caution:
latched onto the hooks on the main unit.
cover to open.
nector (white) on the controller board of the main unit.
into the electrical box.
corner panel 4 from the side of the electrical box on the main unit and connect to
the connector CN4Z and CN5Y on the controller board.
slack using the clamp into the electrical box.
Note:
Make sure wires are not caught in the electrical box cover.
* If the position of the i-see Sensor was changed from default position (Position 3)
to the other position, change the function settings. (Refer to page 11 and Fig. 9-10)
unit. (Refer to Fig. 9-10)
Position 1
Position 2
Position 3
-
1 with screw 3.
17