Publicité
Liens rapides
FRONT UNDER SPOILER
PART.No
①
⑤
×２
pattern set
⑧
pattern
pattern
ＡＲＨ
pattern
ＤＲＨ
pattern
ＥＲＨ
E2410VA000
×１
⑥
⑦
×２
pattern
ＡＬＨ
ＢＲＨ
pattern
pattern
9.5mm
6mm
FUJI HEAVY INDUSTRIES, LTD.
②
×１４
×２
pattern
ＢＬＨ
ＤＬＨ
ＥＬＨ
3mm
(1)
Applicable : WRX, WRX-STI
INSTALLATION INSTRUCTION
GUIDE D'INSTALLATION
EINBAUANLEITUNG
MANUALE D'INSTALLAZIONE
MANUAL DE INSTALACION
③
④
×１４
pattern
pattern
ＣＲＨ
pattern
pattern
ＦＲＨ
＋
8mm
⊿01
(2015MY~)
×１４
ＣＬＨ
ＦＬＨ
×１
140219
Publicité
Manuels Connexes pour STI E2410VA000
Sommaire des Matières pour STI E2410VA000
- Page 1 ⊿01 Applicable : WRX, WRX-STI (2015MY~) FRONT UNDER SPOILER INSTALLATION INSTRUCTION GUIDE D'INSTALLATION EINBAUANLEITUNG MANUALE D'INSTALLAZIONE MANUAL DE INSTALACION PART.No E2410VA000 ① ② ③ ④ ×１４ ×１４ ×１４ ×１ ⑤ ⑥ ⑦ ×２ ×２ ×２ pattern set ⑧ pattern pattern...
- Page 2 ＜CAUTION＞ (1) Perform installation properly according to the procedures indicated in the instruction manual. Improper installation can result in damage to your vehicle or serious injury. (2) Be careful when driving after installing this product as ground clearance at the wheel arch and center section is decreased by approximately 2 cm (0.8 inches) and 3.5 cm (1.4 inches) respectively.
- Page 3 NOTE: This instruction shows only LH side. Please repeat the steps on RH side. detergent pattern ⑧ Ａ pattern ⑧ Ｂ pattern ⑧ Ｃ pattern ⑧ Ｄ pattern ⑧ Ｅ Attach pattern sheets ( to under the bumper surface, and then mark to the intersection on the pattern sheets.
- Page 4 3mm →6mm →9.5mm clip pattern ⑧ Ｆ Attach pattern F sheet to the bumper surface, and then mark to the intersection on the pattern ⑧ Ｆ pattern sheet. Tip : Turn steering wheel to opposing side to provide enough clearance for drilling. 3mm→6mm...
- Page 5 ③ ③ ③ ③ ③ ③ ③ ⑦ Please use the new clips included in this kit. ⑤...
- Page 6 Bumper × ○ Front Under Spoiler Be careful not to rolled up the edge rubber between the bumper face and the Front Under Spoiler. １ ２ ３ ４ ④ ④ ④ ② ④ ５ ② ② ② ④ ６ ② ④...