Publicité
Liens rapides
FRONT UNDER SPOILER
PART.No
①
pattern set
⑨
pattern
pattern
ＡＲＨ
pattern
pattern
ＤＲＨ
E2410CA000
×１
pattern
ＡＬＨ
ＢＲＨ
pattern
ＤＬＨ
ＥＲＨ
9.5mm
6mm
FUJI HEAVY INDUSTRIES, LTD.
②
③
×１２
⑤
⑥
×２
pattern
pattern
ＢＬＨ
pattern
ＥＬＨ
＋
3mm
(1)
Applicable : BRZ (13MY~ )
INSTALLATION INSTRUCTION
GUIDE D'INSTALLATION
EINBAUANLEITUNG
MANUALE D'INSTALLAZIONE
MANUAL DE INSTALACION
④
×１２
×１２
⑦
×２
×２
pattern
ＣＲＨ
ＣＬＨ
×１
8mm
140221
⊿00
Publicité
Manuels Connexes pour STI E2410CA000
Sommaire des Matières pour STI E2410CA000
- Page 1 ⊿00 Applicable : BRZ (13MY~ ) FRONT UNDER SPOILER INSTALLATION INSTRUCTION GUIDE D'INSTALLATION EINBAUANLEITUNG MANUALE D'INSTALLAZIONE MANUAL DE INSTALACION PART.No E2410CA000 ① ② ③ ④ ×１ ×１２ ×１２ ×１２ ⑤ ⑥ ⑦ ×２ ×２ ×２ pattern set ⑨ pattern pattern...
- Page 2 ＜CAUTION＞ (1) Perform installation properly according to the procedures indicated in the instruction manual. Improper installation can result in damage to your vehicle or serious injury. (2) Be careful when driving after installing this product as ground clearance at the wheel arch and center section is decreased by approximately 1 cm (0.4 inches) and 4 cm (1.6 inches) respectively.
- Page 3 NOTE: This instruction shows only LH side. Please repeat the steps on RH side. detergent pattern ⑨ pattern Ａ ⑨ Ｂ pattern ⑨ Ｃ pattern ⑨ Ｄ Attach pattern sheets ( Ｄ to under the bumper surface, and then mark to the intersection on the pattern sheets.
- Page 4 3mm →6mm →9.5mm MUD GUARD pattern ⑨ Ｅ FRONT BUMPER Attach pattern E sheet to the bumper surface, and then mark to the intersection on the pattern ⑨ Ｅ pattern sheet. Tip:Turn steering wheel to opposing side to provide enough clearance for drilling.
- Page 5 ③ ③ ③ ③ ③ clip ③ ⑤ ⑦ Please use the new clips included in this kit. ⑥...
- Page 6 Bumper × ○ Front Under Spoiler Be careful not to rolled up the edge rubber between the bumper face and the Front Under Spoiler. １ ２ ３ ④ ④ ④ ④ ４ ② ② ② ④ ５ ② ④ ６ ②...