Page 1
⊿00 Applicable : WRX (18MY~ ) FRONT UNDER SPOILER INSTALLATION INSTRUCTION GUIDE D'INSTALLATION EINBAUANLEITUNG MANUALE D'INSTALLAZIONE MANUAL DE INSTALACION PART.No E2410VA030 ① ② ③ ④ ×1 ×14 ×14 ×14 ⑤ ⑥ ⑦ ×2 ×2 ×2 pattern ⑧ ×1 + 9.5mm...
Page 2
<CAUTION> (1) Perform installation properly according to the procedures indicated in the instruction manual. Improper installation can result in damage to your vehicle or serious injury. (2) Be careful when driving after installing this product as ground clearance at the wheel arch and center section is decreased by approximately 1 cm (0.4 inches) and 4 cm (1.6 inches) respectively.
Page 3
NOTE: This instruction shows only LH side. Please repeat the steps on RH side.
Page 4
Front Bumper Attach pattern sheets to under the bumper surface, and then mark to the intersection on the pattern sheets. Attach pattern sheets to the pattern ⑧ edge of the bumper. Front Bumper clip 3mm →7mm →9.5mm Inner Parts Front Bumper ※3 Be careful not to hit the inner parts with the drill.
Page 5
Front Bumper 3mm →6mm Front Bumper ③ Front Bumper Front Bumper Mud Guard ⑤ ⑥ ① Please use the new clips included in this kit. ⑥...
Page 6
⑦ ④ ② Bumper × ○ Front Under Spoiler Be careful not to rolled up the edge rubber between the bumper face and the Front Under Spoiler.