Honda HON-JAZZ-5-B Manuel De L'utilisateur page 4

REAR DOOR
Installing the Clip
1. Open the left rear door.
2. Check the positions where the clip are installed
and clean the surfaces with the cleaner provided
from the kit.
LEFT REAR DOOR
4 CLIP INSTALLATION
POSITIONS
• Clean the surface with
a cleaner.
3. Measure each clip installation position to the
dimensions shown.
4. Mark with a felt-tip pen the position of the
measured dimension of the door sash.
CLIP INSTALLATION
POSITION
30 mm
(1.2 in.)
DOOR SASH
Make marks with
felt-tip pen as
shown.
30 mm
(1.2 in.)
5.
6.
Align with the
end of the
radius.
8313020R
80 mm
(3.1 in.)
7.
80 mm
(3.1 in.)
8313031R
4
Remove the adhesive backing from each clip.
Align the edge of the clip with the mark on the door
sash, and attach the clip on the door sash as
shown.
• Be careful in the attachment direction of four
clips.
• Hold the adhesive tape of the clip back side
firmly against the door sash for 15 seconds
after attaching the clip.
• Erase the marks put with the felt- tip pen.
<SECTION VIEW>
LARGE
SMALL
TAB
TAB
Align the edge of the
clip with the mark
made in the step 4.
CLIP
4 ADHESIVE
BACKINGS
• Remove.
CLIP
MARK
Repeat the procedure to install the clip on the right
side.
DOOR
GLASS
MARK
CLIP
CLIP
MARK
8313041R
© Honda Access Europe NV. 2008