Door Glass Installation - Continental Fireplaces CEFVC32H Manuel D'installation

finishing
EN
3.3

door glass installation

WARNING
!
• Facing and/or finishing material must not interfere with air flow through air openings, louvre openings, operation
of louvres or doors, or access for service. Observe all clearances when applying combustible materials.
• Before the door is removed, turn the appliance off and wait until the appliance is cool to the touch. Doors are
heavy and fragile, so handle with care.
1. Remove the retainer bracket by removing the 2 screws (Fig. 1). Note the orientation of the retainer
bracket.
2. Place the glass into the track located inside the firebox (Fig. 2).
3. Push the top of the glass against the top of the plastic panel (Fig. 3).
4. Install the retainer bracket to the top of the appliance as shown, using the 2 screws previously removed in
Step 1 (Fig. 4 and 5). Glass should be fixed after installation.
Fig. 4
16
W415-1831 / D / 01.07.19
Glass
Track
Fig. 1
CAUTION:
Bracket hooks must ALWAYS face
towards the front of the appliance
(Fig. 5). Failure to comply with these
instructions could create a fire hazard.
Fig. 2
Some components
hidden for clarity
Fig. 5
Fig. 3