Steca StecaGrid 8 000+ Notice D'installation Et D'utilisation page 54

EN
7.3.4 Other important display fields
Reset maximum values dialog
Select measurements
Acoustic alarm
Backlighting
52
The Reset maximum values dialog allows the following stored
maximum values to be reset to 0:
• Maximum daily power
• Maximum daily yield
• Absolute maximum power
Selection of the measurements to be shown in the status
display. The following measurements can be selected:
• Output power: output power of the inverter
• Reactive power: current reactive power in var
• Act. day yield: daily yield from 0:00 until now.
• PV voltage: the voltage supplied by the solar modules
• PV current: the current supplied by the solar modules
• Grid voltage L1 , L2, L3
1)
• Grid current L1, L2, L3: the current fed into the mains
grid
• Grid frequency
• Internal temp.: the internal temperature of the inverter
• Power reduction (Derating): cause of the power reduc-
tion
• Day max. power: the maximum power supplied in the
current day
2)
• Abs. max. power: the maximum power ever fed into the
grid
2)
• Day max. yield: the maximum daily yield achieved
• Operating hours: the operating hours during which the
device has been connected to the grid (including night-
time hours)
• Total yield: yield since commissioning
• CO saving: CO
savings achieved since commissioning
2 2
Measurement is always displayed (cannot be switched off)
1)
Can be reset to 0 via Settings/Reset max. values
2)
An acoustic alarm sounds (approx. 4.5 kHz) when an event
message is displayed.
• 2 tones: warning
• 3 tones: error
• off
• automatic: switches on for 30 seconds when a button is
pushed
• grid feed:
Not feeding: switches on for 30 seconds when a but-
–
ton is pushed; then switches off
Feeding: switches on for 30 seconds when a button is
–
pushed; then dims
1)
2)
.
744.378 | 12.13