Engine/Fuel Warnings - Dos; Single Edge Models - Little Wonder 2230S Manuel D'instructions

ASSEMBLy
don't start, run this trimmer indoors, or in an improperly
ventilated area as poisonous carbon monoxide and other
gasses are emitted.
don't run engine when electrical system causes spark
outside the cylinder. During periodical checks of the
spark plug, keep plug a safe distance from cylinder to
avoid burning of evaporated fuel from cylinder.
don't check for spark with spark plug or plug wire re-
moved and grounded. Use an approved tester. Sparks
can ignite fumes.
don't crank engine with spark plug removed. If the
engine is flooded, open the choke (push choke knob in)
and pull recoil until engine starts. If this fails read and
follow the Starting a Flooded Engine section on page
10 of this manual.
don't run engine when the odor of gasoline is present
or other explosive conditions exist.
don't operate the unit if gasoline is spilled. Clean up
spill completely before starting engine.
don't refuel indoors or in an improperly ventilated area.
don't operate your trimmer if there is an accumulation
of debris around the muffler, and cooling fins.
don't touch hot mufflers, cylinders or cooling fins as
contact may cause serious burns.
ENGINE/FUEL wARNINGS – dOS
Always use fresh gasoline in the fuel mixture. Stale
gasoline can cause leakage.
Always pull starter cord slowly until resistance is felt.
Then pull cord rapidly to avoid kickback and prevent
arm or hand injury.
Always operate engine with spark arrestor installed and
operating properly. The use of spark arrestor mufflers
is required by law in the state of California (Section
4442 of the California Public Resources Code), as well
as in other states or municipalities. Federal laws apply
on federal lands.
This spark ignition system meets all requirements of
Canadian Interference-causing Equipment Regulations.
Always handle fuel with care; it is highly flammable.
Never add fuel to a machine with a running or hot engine.
Do not inhale fuel fumes as they are toxic.
8
Blades are extremely sharp! To avoid injury
when unpacking the hedge trimmer, do not
grasp the blades.
Improper assembly of this trimmer can result in
serious injury. Make sure to follow all instructions
carefully.
If you have any questions, contact your local
dealer or our factory at (215) 357-5110.
Your Little Wonder hedge trimmer has been assembled
®
for you at the factory. Before operating be sure all fasten-
ers are secure, and all guards and safety devices are in
place and operating properly.

SINGLE EdGE MOdELS

1. Remove the cutter bar assembly, the engine with
handle and throttle assembly, the side handle, and
hardware bag from their boxes.
2. Place the front side handle over the two 1/4-28 studs
protruding from the frame bar in front of the gear
housing. The handle grip must be pointing away
from the cutting blades as illustrated (Figure 1). On
Model 2230S use the set of studs which places the
handle in the most comfortable position for you. Place
the thread protectors over the set of studs that you
choose not to use at this time to protect the threads.
Secure the handle in place using two 1/4-28 flange
locking nuts provided. The nuts should be tightened
enough to keep the handle from moving but not so
tight as to crush the plastic.
LITTLE
WONDER
TRImmER
Figure 1