Battery Recycling - Panasonic EY7881 Instructions D'utilisation

Battery Recycling

EN
ATTENTION:
For environmental protection and recycling of materials, be sure that it is disposed of at
an officially assigned location, if there is one in your country.
Information for Users on Collection and Disposal of Old Equip-
ment and used Batteries
These symbols on the products, packaging, and/or accompanying documents
mean that used electrical and electronic products and batteries should not be
mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batter-
ies, please take them to applicable collection points, in accordance with your
national legislation and the Directives 2012/19/EC and 2006/66/EC.
By disposing of these products and batteries correctly, you will help to save
valuable resources and prevent any potential negative effects on human health
and the environment which could otherwise arise from inappropriate waste
handling.
For more information about collection and recycling of old products and batter-
ies, please contact your local municipality, your waste disposal service or the
point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in accordance
with national legislation.
[For business users in the European Union]
If you wish to discard electrical and electronic equipment, please contact your dealer or
supplier for further information.
[Information on Disposal in other Countries outside the European Union]
These symbols are only valid in the European Union. If you wish to discard these items,
please contact your local authorities or dealer and ask for the correct method of disposal.
Chisel Attachment (EY9HX402E)
(will be included with shipment
according to the destination)
CAUTION:
• The Chisel attachment is intended to
be used with Rotary hammer EY7880/
EY7881. When used on another tool,
it may create a risk of injury.
• Disconnect Battery pack from tool or
place the switch in the locked off
position before attach or remove the
Chisel attachment. Such preventive
safety measures reduce the risk of
starting the tool accidentally.
• Apply the lubricant grease on the
shaft in the Chisel attachment before
use.
• The Chisel attachment creates heat. It
may become very hot and may cause
skin burns. Do not operate the Chisel
attachment more than 30 minutes
continuously.
• To reduce the risk of injury, use the
Support handle on the Rotary
hammer.
• Replace the Chisel attachment imme-
diately when the Dust protect rubber
cap is broken to avoid the dust
coming inside the attachment.
Usage:
• Use with a Chisel bit with SDS-Plus
type shank in Rotation+Hammer
mode, for Light duty chiseling (ceram-
ic tile remove, scraping sealing mate-
rial etc.)
- 18 -