Allen-Bradley SLC 500 Notice D'installation page 13

Description:
Certification
(when product is
marked)
(1) The combination of all output power (5 volt backplane, 24 volt backplane, and 24 volt user source) cannot exceed 70 watts.
(2) Power supply fuse is intended to guard against fire hazard due to short-circuit conditions. This fuse may not protect the
supply from miswiring or excessive transient in the power line.
(3) Fuse sizes specified are for end-devices only. Fuse size may need to be reduced depending on the size of circuit wiring.
(4) Equivalent fuses: 250V-3A fuse, nagasawa ULCS-61ML-3, or BUSSMAN AGC 3
(5) Equivalent fuse: 250V-3A fuse, SANO SOC SD4, or BUSSMAN AGC 3
(6) Equivalent fuse: 125V-3A fuse, Nagasawa ULCS-61ML-5, or BUSSMAN AGC 5
(7) Use time-delay type overcurrent protection in all ungrounded conductors.
(8) Isolation is between input terminals and backplane.
(9) No isolation between input terminals and backplane. However, dielectric withstand between input terminals and chassis
ground terminal is 600V ac RMS for 1 s.
(10) CPU hold-up time is for 0V unless specified. Hold-up time is dependent on power supply loading.
(11) See the Product Certification link at www.ab.com for Declarations of Conformity, Certificates, and other certification
details.
Specification: 1746-
P1 P2
UL Listed Industrial Control Equipment for Class 1, Division 2,
Groups A, B, C, D Hazardous Locations
C-UL Listed Industrial Control Equipment for Class 1, Division 2,
Groups A, B, C, D Hazardous Locations
(11)
CE
European Union 89/336/EEC EMC Directive, compliant with:
EN 50082-2 Industrial Immunity
EN50081-2 Industrial Emissions
European Union 73/23/EEC LVD Directive, compliant with:
EN61131-2 Programmable Controllers
C-Tick
Australian Radiocommunications Act, compliant with:
AS/NZS 2064 Industrial Emmissions
SLC 500™ Power Supplies
P3
Publication 1746-IN004D-MU-P - May 2003
13
P4
UL Listed Industrial
Control Equipment
CSA Certified
Process Control
Equipment for
Class 1, Div 2,
Groups A, B, C, D
Hazardous Locations