Mx Onda MX-CE2254 Manuel D'instructions page 35

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 50
6. To disable the timer first unlock your keypad by pressing and hold for 2
seconds the unlock button 8 (
then press the on / off timer 6 (
alerting you that the timer is disabled.
Attention:
For security, the timer turns off every time:
• There is a power outage or power failure.
• After activate automatically, remember to make new coffee, the coffee
must be prepared (with water and coffee).
CLEANING
Unplug the appliance from the mains socket and wait until it is completely
cold before cleaning it.
Separate the pitcher of the base support and place it on a stable, level
surface, remember that you must be completely cold.
As described in paragraph (coffee preparation) separates the boiler C to
pitcher B.
Remove the funnel filter K (in the case of the coffee used to prepare three
cups of coffee) and filter - coffee container and pull J coffee deposits which
are in the filters.
Drain any water in the main body C.
On the inside of the pitcher are located on D filter and rubber gasket E.
With the help of a flat object remove the rubber gasket, taking precaution to
avoid damage and remove the filter.
Proceed to cleaning these parts. If the holes are plugged filter D use a pin
or similar object to open the holes. Once clean and dry put them back in
place.
To clean these accessories we recommend you use warm soapy water, do
not use pads that scratched surfaces solvents or abrasives that might
damage the surface.
The main body and the base can be cleaned with a damp cloth, drying
them thoroughly with a dry cloth. Do not soak these parts in water or under
a faucet. Do not use abrasive products and brings them into the
dishwasher.
Once all parts are clean and completely dry, proceed to refit the coffee.
) and the LED keypad locked 9 turns off,
) and the LED indicator on timer goes off,
11

Publicité

Table des Matières
loading

Table des Matières