Power Saving Mode - Mx Onda MX-CE2254 Manuel D'instructions

INSTALLATION OR REPLACEMENT BATTERY
To keep the current time and the timer (in case of failure of the power supply),
the coffee maker needs a 3 V battery type CR 2032. To install or replace the
battery, follow these steps:
1. Using a flathead screwdriver or similar object (round tip of a knife for bread,
for example), turn counterclockwise to clockwise the battery cover which is
located on the back of the support base, Figure 1.
2. To place the battery so that the positive terminal (+) is facing up, then snap
the edge of the plastic tabs in and push until it is retained, Figure 2.
3. To remove the battery slide the metal tab outwards (you can use a sharp
object), and the battery will eject, figure 3.
4. Replace the battery cover and turn it clockwise clock, make sure the cap is
properly retained, Figure 4.
Fig 1
Notes:
• If the battery is not placed, both the current time and the timer will be
cleared immediately after disconnecting the power cord from the power
supply.
• The battery used in this coffee maker contains polluting materials to the
environment, therefore, after exhausting life of it NOT throw away, drop it
in the right places for recycling.

POWER SAVING MODE

The coffee maker incorporates a power saving system which consists of the
automatic screen off after 2 minutes.
When the screen is off (power saving mode) to turn on the coffee maker or the
timer, adjust the clock or timer, it is necessary to press the power button 2 (
Very important:
When the timer is activated, the screen remains lit to warn of this so that the
coffee will automatically connect to the preset time.
Fig. 2
7
Fig. 3 Fig. 4
).