Setting The Clock - Mx Onda MX-CE2254 Manuel D'instructions

SETTING THE CLOCK

This coffeemaker incorporates a 24 hours format clock. To setting the clock,
follow these steps:
1. After installing the battery, plug the base F of coffee maker to a mains
socket, the display will light the digits.
2. If the display is off (power saving mode) press the power button 2 (
3. Press the start button on the clock 4 (
hours. Pressing and holding this button will take the count up automatically
and if pressed and held for more than 7 seconds, the speed will increase
the count up to facilitate setting the time.
4. After setting the hour and minute stop pressing the 4 button (
display digits flashing, wait 5 seconds without pressing any button and the
time will be stored.
Notes:
• Remember that if the screen is off (power saving mode) before pressing
the button will momentarily switch 2.
• The adjustment of hours is done by increasing the times of minutes.
PREPARATION OF COFEE MAKER
Filling the water tank
1. Check that the support base is disconnected from the mains socket and the
machine is completely cooled.
2. Hold the main body C and turn left (counter clockwise) the transparent jar
B. When fully unscrewed the jar separate from the main body.
3. Remove the filter separator K, pulling up.
4. Remove the filter - coffee container J.
5. Fill the tank with fresh water, if you want to make coffee for 6 cups level
should be up to the safety valve. When you want coffee to 3 cups water
level should be 0.8 inches below the safety valve.
The valve can also be seen from inside the water tank of the main body,
that will serve as a reference for filling water.
6. Replace the filter - coffee container for J inside the tank, insert slowly so
that the water does not spill again.
) to increase the minutes and
8
).
) and the