Error Displays And Troubleshooting - Nissei DS-400 Manuel D'instructions

Recalling measured data
Press MEMORY BUTTON to see stored data.
1
When no measurements are stored, nothing will be
displayed.
The memory data is displayed for approximately 5
seconds. Approximately 5 seconds after MEMORY
BUTTON is released, the apparatus will turn off or return
to the current measurement display.
2 Press MEMORY BUTTON to move to next
stored data.
Every depression of the button switches among the
memory data.
The result with memory data number " " is the latest
stored result and results with larger memory data
number indicate the older results.
Press POWER BUTTON and turn off the unit.
3

ERROR DISPLAYS AND TROUBLESHOOTING

ERROR SYMOL / SYMPTOM
MEASURE-
MENT
ERROR
OVER-
PRESSURI-
ZATION
CAUSE / CHECK POINT
TUBE PLUG is not correctly
inserted.
The cuff is not properly
wrapped.
Measurement could not be
made because of moving or
talking during measurement.
Inflation was not enough.
The cuff was inflated to the
maximum pressure.
- 13 -
MEMORY FUNCTIONS
Storage
cancelled.
The stored data will be
retained even after the
power is turned off.
The stored data will be
lost after
replacement.
While MEMORY BUTTON is
held down for approximately 2
seconds, the memory data
numbers will be fast-forwarded
to the average of total stored
data unless the button is
released; the number stops at
release of the button.
REMEDY
Make sure that TUBE PLUG is
securely inserted.
Make sure that the cuff is
wrapped properly.
Remain still and quiet during
measurement.
Inflate the cuff when the
inflation mark is displayed.
Do not inflate the cuff over
300 mmHg.
cannot be
battery