Rig Bar/Panel Assembly; Bottom View - Chauvet Professional F3 Mode D'emploi

Mounting

Rig Bar/Panel Assembly

Alignment Conical (x2)
Spring
Knob
Locking Bar
1. Insert alignment conicals into the alignment holes and allow magnets to connect.
2. Insert the Rig Bar Speego locking bars into the female Speego connections on the F3.
3. Twist the spring knob on the Rig Bar Speego by 90°, until it locks into place.
4. Twist the tightening knob clockwise until F3 is secure to Rig Bar.
5. To detach the Rig Bar from the F3, reverse the previous steps.
• The alignment magnets on the F3 and F-Series Rig Bar are designed to temporarily
hold the weight of the panel to allow the user to properly align and tighten the panel
into place.
• Either side of the F3 with female Speego connections can attach to the F-Series Rig
Bar, but only the short side has alignment conicals and magnets. When attaching
the long side of the F3 to the Rig Bar, take care to ensure that the pixels across the
video assembly are aligned properly.
Warning! The magnetic attachments are not load-bearing, and are intended for
alignment assistance only. Do not release panel until the hanging hardware has been
fully secured.
F3 User Manual Rev. 4
Rig Bar
Locking Latch
Rig Bar Speego
Tightening
Knob
Alignment Magnets
Alignment Holes
Male Speego Connection
Bottom View
Top View
Rig Bar
Locking Tab
10