Remington Power Pro 500V Mode D'emploi page 6

Safety Precautions
?
?
?
G 018
7. An operator taking medication should take extra precautions while handling the
tool. NEVER drink alcoholic beverages or take medications which impair your
vision, balance, or judgement before using a powder actuated tool.
KNOW YOUR FASTENING BASE MATERIAL
?
Point
flattens
TOO HARD
G 018
482-29
1. ALWAYS know the thickness and type of base material into which you are
fastening. NEVER GUESS. Test the base material by using the Center Punch
Test. The Center Punch Test is performed by using a hammer to test drive the
particular power fastener to be used into the material. If the point penetrates easily,
the material is too soft. If the point becomes blunt, the material is too hard. If the
material fractures, cracks, or shatters, the material is too brittle. Test fastenings can
be made if the material shows a clear fastener impression and the fastener point
is not blunted. ALWAYS use test fastenings to determine the correct power load
level and the tool's power indicator setting (see Power Loads and Power Indicator
Setting, page 13). Operators and bystanders must ALWAYS wear eye and ear
protection which meet or exceed the accepted standards for adequate protection
in your country. In the USA, refer to ANSI standards. In Canada, refer to CSA
standards.
?
?
?
482-26
Surface
shatters
TOO BRITTLE
CENTER
PUNCH TEST
482-27
G 018
482-30
6
Sinks in
with
average
hammer
blow
TOO SOFT
482-28
G 018
Start
GREEN
POWER
LEVEL 3
YELLOW
POWER
LEVEL 4
RED
POWER
LEVEL 5
114918