Tool Disassembly And Assembly - Remington Power Pro 500V Mode D'emploi

Tool Disassembly and
Assembly
WARNING: ALWAYS unload a powder actuated tool before disassembling,
replacing barrel, cleaning, or assembling.
TOOL DISASSEMBLY
A. REMOVING BARREL ASSEMBLY
1. Using screwdriver, lift end of annular spring and rotate spring until stop is
uncovered (see Figure 1).
Figure 1 - Rotating Annular Spring to Uncover Stop
2. Push stop towards rear of tool and remove (see Figure 2).
3. Firmly grip and pull barrel assembly from the outer liner assembly.
4. Unscrew muzzle cap.
5. Pull buffer out of muzzle cap (see Figure 3).
Muzzle Cap
Figure 3 - Separating Barrel Assembly from Housing
6. Pull piston assembly, using moderate force, from barrel (see Figure 4).
Figure 4 - Removing Piston Assembly from Barrel
Figure 2 - Removing Stop
Barrel Assembly
Buffer
Piston
Piston Assembly
Annular Spring
Stop
Stop
Outer Liner Assembly
Barrel
18
114918