Dicota Phasor Mode D'emploi page 5

Setup the connection RF channel between the mouse and the
receiver
1.
Push
Push the channel reset button on the mouse. Push the channel reset
button on the receiver. If the cursor does NOT move after 30
Caution: If you have completed the connection successfully, the LED on
the receiver will flash several times. If the RF Channel is not connected
properly, please reset RF Channel again by following the above steps.
Please re-setup the RF Channel after you replace the batteries.
seconds, please do the step above.
2.
Push
LED FLASH (0.5 sec. regularly).
Searching the channel.
LED FLASH (if any action).
Channel connected.
LED ON.
No action.
5